Washer Repair in Post Falls, ID

The City of Post Falls Water Division's 2023 water quality report reported an average operating pressure of 65 to 75 psi, higher for customers farther south and lower for those farther north. That is within the 20 to 100 psi Whirlpool lists for one of its washers, but a rubber fill hose maintains that pressure whenever the tap is open, between loads and during them. Two habits help: close the taps between loads, and replace the hoses at the five-year mark. Both are the maker's advice for any house; on the higher-pressure south side of the system, they are the ones not to skip.

Whirlpool's use-and-care guide sets replacement at five years of use, says to inspect hoses for bulges, kinks, cuts, wear or leaks, and says to record installation or replacement dates. Few households know how old their hoses are because they arrived with the machine or the house. When new ones go on, write the date on a tag or a strip of tape around one of them.

The faucets usually sit close by, since installation instructions call for them to be within 3 feet of the fill valves, so the hoses are short and their ends are often visible from beside or above the machine. A look behind the washer, with the machine unplugged, is worth doing a few times a year.

Unplug the washer and use a flashlight from the side or from above. None of these checks require the machine to be moved or a panel to be removed.

The hose itself

Look along each fill hose. A bulge, a crack in the rubber, or a kink where the machine was pushed back against the wall is a reason to close that tap until the hose is replaced.

The two ends

Look at the coupling on the tap and the one on the back of the washer, ideally just after a fill. A bead of water at either end, a crust around a fitting or a rust stain on the floor below a tap points to a connection that has started to leak slowly. A coupling can drip because its small rubber gasket has hardened or slipped out of place, which is a different job from a hose that has failed along its length.

The tub between loads

Water in a tub that was empty after the last load drained, with no one having added it, suggests the inlet valve is not closing completely. Higher pressure can exert greater force on a worn valve seat. Turning off both taps stops the creeping fill until the visit.

If the trouble is draining, spinning or a leak at the door, Washer Repair walks through those; front loaders and top loaders leak from different places, so the machine type is the first thing to say.

Yes. The five-year interval counts years of use, so a clean outside is only part of the answer. Look at the rubber close to each end, where a hose bends and flexes most, and replace any hose that shows a bulge or a crack sooner.

Yes, on any address, and it is the habit not to skip toward the south of the system. Closing them takes the pressure off the hoses while the washer sits idle. Whirlpool's guide says to turn off the water supply to the washer to prevent flooding from water pressure surges, and to shut off both faucets for winter storage.

Yes. Inlet hoses and their connections are part of the washer work, and a maintenance check includes inspecting them. Ask when you book, and say which hoses are on the machine now.

The hose advice does, since the five-year interval is the maker's. The city's pressure figures do not: a well or another water district sets its own pressure, which a plumber can measure at your tap.

The service call is $89. It covers travel, inspection, and diagnostic time. It goes toward the repair if you go ahead, and it stands on its own if you decide not to.

Once the leak is traced to a hose, a coupling, or the valve behind them, the repair is named and priced.

Parts and labor are warranted for 30 to 90 days as stated on your invoice, with the full terms at Warranty.

Zero-interest financing through Wisetack is available on repairs over $500 for eligible customers, and active-duty service members and veterans get 15% off labor. Terms are at Financing.

Request a Repair